When I started working on the elements of this bag, I had no intention of making a bag. I was simply going to do a quick blog showing how Derwent Inktense can be used successfully on fabric, since it is set permanently once dry. You can read more about that here. When I was done, I liked the panel that I had painted so much that I wanted to use it somewhere where it could be seen. The Artbag immediately sprang to mind. I painted a second panel and then set out to paint the handles for the bag in much the same way, again using Derwent Inktense. You can read about that here.
Not having cut the fabric I was working on with the specific intent of using it on the Artbag, I now had to cut the panels to the desired size. However, not wanting to cut too much of the painting away, I opted to retain the width and only trimmed the length. I'll show you how I accommodated the extra length in the bag when we get there in the construction.
I was also going to be adding a sling to this bag, so I needed to cut some extra pattern pieces that was not part of the original pattern. I cut two pieces that would be used to attach the loops to the bag. They should be 15 x 10 cm in size.
I also needed to cut the sling itself. I cut it approximately 70 cm in length by 20 cm in width.
I started with the zipper at the top of the bag. Sandwich the zipper between the fabric and the lining of the zipper flap. Pin in place and stitch as close as possible to the zipper.
Repeat the steps for the other side of the zipper as well.
Iron the zipper flat.
Sandwich the pocket zipper between the two panels for the bottom. Pin in place and sew as close as possible to the zipper.
With the right sides of the bottom panels facing, sew down the sides, starting at the zipper and ending at the bottom.
Cut the excess fabric away in the corners (where the zipper is) and turn the bottom of the pocket inside out.
Sandwich the other side of the zipper between the top panels of the zipper pocket. Pin and stitch as close as possible to the zipper.
Fold and pin the bottom pocket out of the way.
Lay the top panels right sides facing on top of each other and pin in place.
Sew the sides closed, starting at the zipper and ending at the top. Sew both sides.
Trim the excess zipper if applicable.
Trim the corners and turn the top panel right side out.
This is what the pocket should lool like.
Iron the pocket flat.
The Open Pocket
Fold the pocket on the fold-line with the right sides facing. Pin. Leaving 2-3 cm open at the top where the fold-line is, sew down the side and all the way around, leaving openings on both sides.
Cut the excess fabric away in the corners opposite the fold-line.
Turn the pocket right sides out.
Sew a channel for the elastic at the fold-line, approximately 10-15 mm in width.
Find the centre of the pocket at the bottom.
Fold a flat pleat at the bottom and pin it in place.
Pull elastic through the channel created for it at the top.
Fold the ends of the elastic away and pin in place.
In the next blog we will prepare the remaining pattern pieces and in the last blog we will pull it all together to construct the bag.
For more crafty ideas and great products, visit APrettyTalent.com.
Remember to keep nurturing your TALENT for making PRETTY things.
You can subscribe to this blog and receive regular updates by email by simply registering your email address at the top of the current blog.